Category Archives: Programing

Programing stuff goes here

ArtNet is not conforming to RFCs

Posted on January 26, 2023 by Faye Bell

For all the Network Techs out there. I have a Interesting one, on reddit there was a post about a L2 switch killing the port when ArtNet was sent over it. Using my Network experience, I pulled the devices manual, … Continue reading →

Posted in Lighting, Networking (computers), Programing, Uncategorized | Comments Off on ArtNet is not conforming to RFCs

square wave power supply

Posted on June 25, 2018 by Faye Bell

I was looking in to my old 800W 120VAC DC to AC supply, to see just how bad the square wave is. The test in my view was not complete. I did not load test the supply. To see how … Continue reading →

Posted in Hardware work | Comments Off on square wave power supply

Asterisk hold music

Posted on July 31, 2017 by Faye Bell

I was working on updating my hold music on my asterisk lines. a quick method of doing this. Is as follows First covert the audio to mono 8000 sample rate “wav” files Then with sox installed for f in *.wav; … Continue reading →

Posted in Programing | Comments Off on Asterisk hold music

Learning Python

Posted on February 24, 2017 by Faye Bell

I have been studying Python, by reading Python Essentials by Steven Lott. It has shown me the basis of the language so far. Coming from a C background, I will be comparing data types to C data types. The array … Continue reading →

Posted in Programing | Comments Off on Learning Python

Industrial Controled Alarm Clock Build Has began

Posted on September 15, 2011 by Faye Bell

Earlier this month I started working on the Industrial controlled alarm clock again. The picture on the left is the SR latch logic for the input buttons. Jonathan Streeter is helping me out by pointing me the right way when … Continue reading →

Posted in Industrial Controled Alarm Clock | Comments Off on Industrial Controled Alarm Clock Build Has began